Circle, bar 10Х17Н13М2Т - 1.4571 - aisi 316Ti

Wire
Round, bar
Tape, foil
Sheet, plate

International Equivalent

Mark Analogue W. Nr. Aisi Uns En Order
10X17H13M2T EI448 1.4571 316Ti X10CrNiMoTi18-12 Delivery from the stock, in stock

Production

Round grade 10X17H13M2T AISI 316Ti is a rod with a circular cross-section. Its cross section can also be oval. In some situations, deviation in ovality is allowed, but the difference between the smallest and largest diameter within one cross-section must not exceed 50%. The production is carried out by cold or hot rolling according to GOST 5632-61 in length up to 6 meters. Circle is characterized by corrosion resistance and high strength. Diameter varies within the range of 2-150 mm. The quality of bars fully meets not only the requirements of the domestic State Standard, but also the standards adopted abroad - DIN EN 10 060-2004.

Composition

Brand 10Х17Н13М2Т (AISI 316Ti) is a complex alloy. It consists of: 0.1% of carbon, about 17% Cr, 13% Ni, 2% Mo, up to 1% Ti. The remainder is iron. The amount of chromium can vary from 12-20%. The higher the amount, the greater the resistance to oxidation. If the amount of chromium is greater than 17%, the alloy becomes resistant to corrosion in an aggressive oxidizing environment. Nickel not only increases corrosion resistance, but also gives the alloy toughness and impact resistance, and molybdenum and titanium give it strength and heat resistance.

Percentage composition of the alloy GOST 5632-72

Grade C Si Mo Cr Ni Mn Cu Ti S P Fe
10Х17Н13М2Т ≤0,1 0,8 2-3 16-18 12-14 ≤2 ≤0,3 ≤0,7 0,02 0,035 basis

Technological qualities

Range GOST σB σT Heat treatment
Forgings 25 054-81 510 196 1050-1100°C hardening, air cooling
Bar Ø 60 5949-75 510 215 Air cooled, hardened 1050-1100°C
Wire 18 143-72 540-830 --- Without heat treatment

σB - ultimate short-term strength;

σT - yield strength for permanent deformation.

Application

Stainless steel circle is one of the most popular types of rolled steel. It is used where there is contact with soil and atmospheric moisture or with aggressive media. Actively used by the marine industry, chemical and food industries, most often - construction for lightning protection systems, in the reinforcement, construction of bridges, high-speed trails, tunnels. In mechanical engineering - for springs, springs, washers , etc. products.

Buy at the best price

Evek GmbH sells a wide range of stainless steel rolled products. When supplying a circle made of steel 10Х17Н13М2Т, the following parameters are taken into account:

  • Precision - high, standard and increased, based on it the product is assigned the appropriate marking A, B or C;
  • Shape - rolled products with a diameter of up to 9 mm are supplied in coils, with Ø> 9 mm - in bars;
  • Length - multiple of measured, measured and unmeasured.

The quality of the product is guaranteed by full compliance with the technological norms of production. Lead times are minimal. In case of bulk purchases we provide preferential discounts.