35g2 - 35s20 - 1.1170 pipe, circle, bar

Sheet, ribbon, wire

International Equivalent

Mark Analogue W. Nr. Aisi Uns En Order
35g2 1.1170 35s20 Delivery from the stock, in stock

Evek GmbH offers to buy tubes, rounds, bars of medium-carbon structural steel grades 35G2, 35S20, 1.1170. Supplier provides cost-effective price of products from its manufacturer, and provides delivery of rolled products to the address specified by the customer.

Chemical composition

In the CIS countries 35G2 steel is produced in accordance with the technical requirements of GOST 4543. The steel contains:

  • 0.31…0.39% carbon;
  • 0.17…0.37% silicon;
  • 1,40…1,80% of manganese.

The nonmetallic impurities in the steel 35G2 (sulfur and phosphorus) may not exceed 0,04% for each of the elements.

Foreign counterparts of this steel are steel grades 35S20 and 1.1170. They are produced in accordance with European standards EN 10084−2006. The difference in chemical composition of these steels in comparison with 35G2 steel is not considerable, as is evident from the table:

Element Carbon Carbon, silicon Carbon, silicon Nickel, chromium Molybdenum
Percentage content in steel 0,25…0,32 Up to 0.40 1,30…1,65 Not more than 0.30 Not more than 0.10

Metallurgical impurities — sulfur and phosphorus — are present in steels in amounts not exceeding 0.05% (phosphorus) and 0.035% (sulfur).

Company Evek GmbH offers to buy at producer’s price tubes, rounds of medium carbon steel grades 35G2, 35S20, 1.1170 with high manganese content. The price — from the manufacturer. Supplier guarantees adherence to the range of supply and timely shipment of products to the location specified by the customer.

Properties and application

The steels under consideration are distinguished by increased hardness after heat treatment. They are effectively used in the manufacture of spatial parts of machines and mechanisms — shafts, gears, gears — the work of which is accompanied by shocks and high contact loads. The steel can be hot stamped, machinability is medium.

Physical and mechanical characteristics:

  • tensile strength, MPa — 530… 570;
  • yield strength, MPa — 260… 290;
  • Relative elongation, % — not less than 18;
  • Brinell hardness after annealing, HB — not above 225.

Evek GmbH offers to buy for economically advantageous producer price bulk rolled products and tubes made of medium-carbon manganese steels 35G2, 35S20, 1.1170. The supplier guarantees compliance with the established range of profiles and timely delivery of rolled products to the address specified by the consumer of rolled products.