L60 - 2.0360 - CuZn40 rod, strip, wire

Relevance

Brass L60 refers to a simple double alloy, contains copper and zinc in an approximate ratio of 60% to 40%. The percentage of copper is reflected in the marking. It is distinguished by high technical characteristics: strength, ductility, resistance to corrosion, good toughness, malleability. The alloy is easily deformed in cold state, stamped, deep-drawn and well polished. It is used for tube boards in freezers, stamped pieces of equipment, fittings.

Production

Chemical composition of L60 grade is regulated by GOST 15 527-2004. Alloy consists of the following components: main part is copper 59 - 62%, zinc contains 37 - 41%. The alloying additives are listed in descending order. Lead - up to 0.3%, iron - 0.2%, phosphorus and antimony - 0.01%, bismuth - 0.003%, - impurities do not exceed 1%. The alloy melts at t° 904 °C, is processed at t° 750 - 880 °C, the annealing temperature is 550 - 650 °C.

Percentage composition of L60 grade (GOST 15 527-2004)

Zn	Cu	Fe	Pb	Sn	P	Bi	Sb	Ni	Impurities
37-41	59-62	≤0,2	≤0,3	---	≤0,01	≤0,003	≤0,01	---	≤1

Advantages

Brass rolling has a number of advantages over the more expensive copper. In particular, brass 60 along with increased strength, easily deforms in cold state, is not prone to corrosion cracking. Increased ductility allows using it for the production of sheet and section rolled products obtained by deep-drawing of strips, bands, foil. Mechanical strength of L60 at t ° 20 ° C: pressed tubes (GOST 494-90) has _sv = 340 MPa, soft alloy has _sv 370 - 420 MPa, _d5 40 - 50%; hard alloy has _sv = 650 - 750 MPa, _d5 2 - 4%.

Application

Brass L60 is widely used for the production of tubes, bars and sheets, heating equipment, parts of cryogenic equipment.

Buy at favorable price

Evek GmbH stocks a wide range of non-ferrous alloys at the best price. The choice satisfies any customer. Brass rolled grade L60 is supplied in wholesale and retail. The popularity of products from this alloy is due to the huge variety and excellent quality of products. All products of our company are manufactured under full control of the process chain, which provides a 100% quality guarantee. We are ready to deliver products of non-standard parameters on an individual order. Technological capabilities at the stages of production allow for individual orders in the absence of the basic version of the required type of product. Lead times are minimal. The price depends on the delivery volume and additional terms of realization. Flexible system of discounts for wholesale orders.