Tape, circle, wire 52H - alloy 52

International Equivalent

Mark Analogue W. Nr. Aisi Uns En Order
52N Delivery from the stock, in stock

Basic properties

Precision alloy 52H (52H-VI) with high magnetic permeability and saturation induction 1,5 T belongs to alloys with a given thermal coefficient of linear expansion (TKLR in the temperature range between minus seventy degrees and +550ºC) and is used for sealed junction with glass. Melting point of the alloy = 1450 °C. Refers to the group of highly alloyed precision alloys with unique physical and mechanical characteristics (elastic, magnetic, thermal, electrical), due to the verified chemical composition, the absence of impurities, precision manufacturing and processing. The main part of precision alloys is produced on the basis of iron and nickel.

The percentage composition of 52H

Si C Fe Mn P S Ni Cu and Cr
up to 0.2 to 0.05 46.42 - 48.5 up to 0.4 up to 0.015 to 0.015 51.5 - 52.5 up to 0.2

Physical properties of the alloy 52H.

MPa Grad 1/Grad J/(kg-grad) kg/m3 W/(m-grad) Ohm-m
E 10- 5 T a 10 6 C r l R 10 9
1.6 20 8200 420

Mechanical properties of alloy 52H at 20 °C.

Thermal treatment.

Range Size sT s in e.g. KCU y d5
mm MPa MPa - kJ/m2 % %
450-550

Physical properties of the alloy:

Description Designation
- Alloy data acquisition temperature [Grad] - T
- Modulus of elasticity of the 1st kind, [MPa] - E
- Coefficient of thermal linear expansion (at 20°C), [1/Grad] -a
- Specific electrical resistance [Ohm-m] -R -R
- Specific gravity [g/cm3] -r -r
- Heat transfer coefficient [W/(m-grad)] -l -l
- Specific heat capacity (at 20°C), [J/(kg-grad) -C

Mechanical properties:

Description Designation
- Ultimate yield strength (yield strength for permanent deformation) [MPa] sT
- Tensile strength [MPa] sT
- Ratio constriction [ % ] y
- Tensile elongation [ % ] d5
- Brinell hardness, in [MPa] HB
- Impact toughness [ kJ/m2 ] KCU

Weldability:

Designation Description
limited weldable - Must be preheated to 100-120°C with subsequent heat treatment
no restrictions - No need for preheating and final heat treatment
Difficult to weld - Preheating to 200-300°C with final heat treatment necessary

Delivery

All the presented 52H products are certified. The technical documentation includes data on the chemical composition, the limiting percentage of impurities, and the mechanical properties of products. From us you can buy in bulk a variety of semi-finished products for large-scale production. We also offer good conditions for retail buyers. You will be satisfied with the level of service and responsiveness of service.

Buy at the best price

The Evek GmbH website provides the most up-to-date information on the purchase of precision alloys to date. Experienced managers who are always in touch are ready to provide highly qualified advice on any current issues. We sell semi-finished products of rare and non-ferrous alloys at a competitive price. Products are manufactured on the most modern equipment and meet the requirements of international quality standards. Regular customers are offered a system of discount discounts.