B95 / 7075 Aluminum Sheet, Strip and Tube

International Equivalent

Mark Analogue W. Nr. Aisi Uns En Order
B95 7075 AlZnMgCu1.5 Availability confirmed on request

Technical characteristics

Through alloying, the alloy acquires additional hardness. Anodic oxidation is used to increase corrosion resistance. Hardness HB 10 -1 = 125 MPa. Hardness after hardening and aging HB 10 -1 = 150 MPa.

Percent composition (GOST 4784−97)

Fe Si Mn Cr Al Ti Mg Zn Cu Impurities
≤0,5 ≤0,5 0,2 — 0,6 0,1 — 0,25 86,2 — 91,5 ≤0,05 1,8 — 2,8 5 — 7 1,4 — 2 ≤0,1

Mechanical properties (temperature 20°C)

Range GOST s in sT d5 Heat treatment
-   MPa MPa % -
Tubes 18482−79 490−510 375−400 5−7  
Bar 21488−97 490−530 390−420 4−6 Quenched and artificially aged
Bar, high strength 51834−2001 550−570 480−490 6 Hardened and artificially aged
Annealed tape 13726−97 245   10  
Profiles annealed 8617−81 275   10  
Physical properties of the material
t°C E 10- 5 a 10 6 l r C R 10 9
Degree MPa 1/Gradus W/(m-degree) kg/m3 J/(kg-degree) Ohm-m
20 0.74     2850    
100   23.2        

sc — Ultimate short-term strength

sT — Limit of proportionality (yield strength for permanent deformation)

d5 — Tensile elongation at break.

HB — Brinell hardness

E — Modulus of elasticity of the first kind

C — specific heat capacity

Analogues

Inter Austria England Germany Italy USA France Czech Republic Switzerland Japan
ISO ONORM BS DIN, WNr UNI AISI AFNOR CSN SNV JIS
AlZn5.5MgCu AIZn6Mg2Cu1.5 7075 3.4365 AiZn5.8MgCuCr 7075 7075 424222 AlZnMgCu 7075
AlZn6MgCu AlZnMgCu1.5 L95 AlZnMgCu1.5 P-AlZn5.8MgCuCr A97075 A-Z5GU      
    L96     AA7075        

Cold working

Plastic deformation, turning, milling, grinding, drilling.

Storage

Stored in covered or roofed warehouses, with adequate protection against mechanical and other types of damage.

Quote B95 or 7075 aluminum by exact specification

This page covers sheet, strip and tube inquiries using B95, 7075 and related designations. The reference table above is a starting point, not proof that two grades or tempers can be substituted. State the governing standard, required alloy and temper, product form, dimensions and quantity. We will check the requested material and documentation before quoting.

For sheet or strip, include thickness, width, length and finish. For tube, include outside diameter, wall thickness and length. See our broader aluminum products catalog.

Request B95 / 7075 Aluminum Pricing

Send exact standard, alloy and temper, form, dimensions, quantity, certificates and U.S. delivery ZIP code.

We will confirm availability, documentation, price and U.S. delivery for the exact request.

Request a Quote