Are you interested in cutting and drilling brass? The supplier Evek GmbH offers a wide range of brass at an affordable price. We provide delivery of products anywhere in the continent. The price is optimal.

Choice of technology

The choice of optimum technology for separating brass billets and semi-finished products depends on the alloy grade and brass grade. Brittle brass containing over 25...30% of zinc is cut mechanically, whereas ductile brass is preferably cut with shears or in dies. Supplier Evek GmbH offers to buy domestic and foreign brass rolled products at an affordable price in a wide range. We provide delivery of products to any point of the continent. Price is optimal.

Cutting with saws

Apply cutting with serrated saws, band saws and mechanical hacksaws (the last two methods are recommended for use in a single production, or in the repair work). Cutting of rolled brass with friction saws is not used. As at the intensive infeeds of a sawing disk and the considerable sizes of cross-section section of brass bars their overheating to temperatures at which allocation of poisonous fumes of zinc begins is possible.

Cutting with scissors

When cutting with bar, plate or combination shears, heating of the billet is not used, which is due to the low values of the shear strength for most brass grades. Increased toughness of the material dictates the use of reduced technological clearances, especially the radial one, which determines the quality of the interface. Brass pipes are cut either on special dies in presses or mechanically. The plastic cutting technology has an advantage, since in this case there is practically no loss of alloy to waste.

Brass Drilling

Getting holes mechanically in ductile materials such as most brass has a number of peculiarities:

• Metal-cutting equipment should be able to work at higher drill speeds - up to 10000...12000 ^min-1;
• Drilling of deep holes, in order to ensure the required accuracy is carried out with the use of conductors;
• In the process of drilling small chips are formed, so periodically the drill should be cleaned;
• In order to preserve the strength of the drill bit it is necessary to periodically supply coolant with low viscosity to the processing zone.

Purchase. Supplier, price.

Are you interested in Cutting and drilling brass? The supplier Evek GmbH offers to buy brass at producer prices. We provide delivery of products anywhere in the continent. The price is optimal. We invite you to partner cooperation.