Sheet, strip 40X - 41cr4 - 40h
International Equivalent
| Mark | Analogue | W. Nr. | Aisi Uns | En | Order |
|---|---|---|---|---|---|
| 45X | 1.7035 | 5140 | 41Cr4 | Delivery from the stock, in stock | |
| 40X | 1.8509 | A322 | 41Cr4 | Delivery from the stock, in stock | |
| 40X | 1.7223 | 5140 | 41Cr4 | Delivery from the stock, in stock |
Evek GmbH offers to buy hot- and cold-rolled sheets and strips made of structural steel grades 40Kh, 41Cr4 and 40h with a higher percentage of chromium. The supplier guarantees compliance with the assortment range of supply, as well as the timely transportation of products to the location specified by the customer.
Chemical composition
In CIS countries medium-carbon alloyed steel 40Х is produced according to
| Component | C | Si | Мn | Cr | Ni | Cu |
|---|---|---|---|---|---|---|
| Content in steel, % | 0,36...0,44 | 0,17...0,37 | 0,50...0,80 | 0,80...1,10 | 0.30 max. | Not more than 0.25 |
The steel also contains metallurgical impurities - sulfur and phosphorus, whose amount in the final product can not exceed 0.035%.
Abroad there are a number of counterparts of 40X steel, among which are steel 41Cr4 (according to European Union standards EN 10083-3 and EN 10263-4), steel 1.7035 (produced according to American standard AISI) and steel 40h (produced according to Polish national standard PNH 84030). The chemical composition of these steels is approximately the same as given in the table, except for the lack of nickel and copper.
Evek GmbH offers to buy sheets and strips of structural chromium steel 40X, 41Cr4, 40h. The supplier provides a cost-effective price from the manufacturer, as well as delivery of the purchased products to the location specified by the customer.
Properties
After rolling in a hot state, these steels are characterized by the following physical and mechanical parameters:
- Ultimate tensile strength - 100 MPa;
- Tensile strength is 80 MPa;
- Tensile elongation - not less than 10%;
- Tensile strength - not less than 6 kJ/m2.
Flat and strip rolled from 40X, 41Cr4 and 40h medium-carbon steel with high chromium content is used for production of toothed racks, body parts of spline couplings, high-strength critical fasteners and other parts with high strength and wear-resistance requirements. These steels are well suited for heat treatment as well as hot forging. The weldability of the steels is limited.
The company Evek GmbH offers to buy sheets and strips of alloyed high-chromium steels. Economical price from the manufacturer is valid. The supplier provides strict adherence to the nomenclature of product supply, as well as its prompt delivery to the address specified by the consumer.