Sheet, strip 18hgt - 20mncr5 - 18hgt
International Equivalent
| Mark | Analogue | W. Nr. | Aisi Uns | En | Order |
|---|---|---|---|---|---|
| 18HGT | 1.7147 | 5120 | 20MnCr5 | Delivery from the stock, in stock |
The company Evek GmbH offers to buy rolled sheets - sheets, strips - of alloy steel grades 18ХГТ, 20MnCr5, 18hgt. Economically advantageous price of the producer is valid. Supplier provides full compliance with the range of dimensions and thickness, as well as timely delivery of products to the point set by the consumer.
Chemical composition
18 KGT structural alloyed steel is produced in CIS countries according to
| Component | C | Si | Мn | Cr | Ni | Cu | Ti |
|---|---|---|---|---|---|---|---|
| Presence in steel, % | 0,17...0,23 | 0,17...0,37 | 1,10...1,40 | 1,00...1,30 | Not higher than 0.30 | Not over 0.20 | 0,06...0,12 |
The standard allows the presence of non-metallic impurities - sulfur and phosphorus, the amount of which may not exceed 0,035%.
The closest foreign equivalents of 18 steel are steel 18hgt (produced in Poland, according to specifications PNH 84030) and steel 20MnCr5 (otherwise - 1.7147), whose composition and properties are governed by Eurostandard EN 10843:
| Component | C | Si | Mn | Cr | S | P |
|---|---|---|---|---|---|---|
| Presence in steel, % | 0,17...0,22 | Up to 0.40 | 0,80...1,10 | 1,00...1,30 | Up to 0.035 | Up to 0,025 |
Evek GmbH company offers to buy sheets and strips of 18ХГТ, 20MnCr5 and 18hgt alloyed structural steel at producer price. The supplier provides strict conformity of rolled products range to the contract terms and timely delivery of products to the address specified by the customer.
Properties and application
Rolled metal products of these steels after heat treatment acquire the following mechanical properties:
- Tensile strength, MPa - 1000;
- yield strength, MPa - 850;
- Tensile elongation, % - 9;
- Tensile strength, kJ/m2 - not less than 80;
- Brinell hardness - 160...255 NV (lower values correspond to hot-rolled sheets).
Sheets and bars of these steels are used for machining and punching of details, exploitation of which is performed under high dynamic loads and which require high wear resistance and fatigue strength, in the presence of bending stresses. Tools made of high-speed steels or hard alloys are used for machining. Steels are characterized by moderate weldability.
Buy sheet and strip of alloyed structural steel 18hGT, 20MnCr5 and 18hgt offers the company Evek GmbH. The price from the manufacturer is valid. Supplier guarantees the performance of the assortment of supply and delivery of products to the point specified by the customer.