Steel АУ10Е (АСУ10Е)

  • U16 steel (EI336)
  • U9A steel
  • U9 steel
  • U8GA steel
  • U8G steel
  • U8A steel
  • U8 steel
  • U7A steel
  • U7 steel
  • U12A steel
  • U12 steel
  • U11A steel (U11)
  • U10A steel
  • U10 steel
  • Steel AU10E (ASU10E)
  • A85 steel
  • Steel A75 (U7AB)

    • Designation

    Name The value
    Designation GOST Cyrillic АУ10Е
    Designation GOST Latin AU10E
    Transliteration AU10E
    By chemical elements -
    Name The value
    Designation GOST Cyrillic АСУ10Е
    Designation GOST Latin ACU10E
    Transliteration ASU10E
    By chemical elements -

    Description

    АУ10Е steel is used: for the production of bars with special surface finish diameter of 1−6 mm, used for the manufacture of parts for watches exposed to the subsequent thermal treatment.

    Standards

    Name Code Standards
    Bars and shapes В32 TU 14-1-2607-78, TU 14-1-3390-82, TU 14-130-263-94

    Chemical composition

    Standard C S P Mn Cr Si Ni Fe Cu Se
    TU 14-1-3390-82 0.95-1.04 ≤0.03 ≤0.03 0.15-0.4 ≤0.15 0.15-0.3 ≤0.2 Rest ≤0.2 0.16-0.24
    Fe is the basis.
    According to TU 14-1-2607-78, TU 14-1-3390-82 the chemical composition is presented for steel grade AU10E. In steel, deviation in selenium content by ± 0.030% is allowed. The introduction into lead steel of up to 0.25% is allowed, with the brand name being changed to ACS10E.

    Mechanical properties

    Section, mm σU, MPa
    Bars with special surface finish as supplied on the other 14-1-2607-78
    1-4 740-980
    4-6 690-880
    Bars with special surface finish as supplied on the other 14-1-3390-82
    1-4 780-980
    4-5.2 740-930

    Description mechanical marks

    Name Description
    σU Limit short-term strength

    Technological properties

    Name The value
    Macrostructure and pollution The fracture of steel bars on the other 14-1-2607-78 controlled on the bars with diameter 3.0 mm and above shall be homogeneous and fine-grained. The break should be free of voids, supernote, delaminations, cracks, bubbles and inclusions visible to the naked eye. Decarbonisation on the bars is not allowed.
    Microstructure Microstructure of steel on the other 14-1-2607-78 should consist of uniformly distributed fine pearlite and must comply with points 1-4 of the scale GOST 801.
    Particularities of production of goods Bars on the other 14-1-2607-78 supplied in cold-worked condition.